|
MECHATRONICS |
EASY CNC STEPPER MOTOR DRIVERS |
TWIN
CNC RELAY BOARD
WITH THIS NEW TOP QUALITY RELAY BOARD YOU CAN SWITCH ON/OFF THROUGH YOUR COMPUTER A MOTOR TOOL, ROUTER OR A COOLANT PUMP, JUST WIRE TO YOUR PC PARALLEL PORT BREAKOUT, PLUG IN A POWER SUPPLY AND CONFIGURE YOUR CAM SOFTWARE
FEATURES
Two relays on board
It can activate/deactivate tools that work at 120VAC or 220VAC as a Motor Tool, Router, Coolant Pumps, etc.
Slave and single mode configuration, selectable on board; for single mode jump pins 2-3 in this mode you can control two different circuits with a control signal each; for slave mode jumps pins 1-2 in this mode you can control two circuits with a single control signal
All inputs signals are optocoupled for computer parallel port protection
If you are not an electronics expert, just follow the instructions in the datasheet. It can not damage your computer because it has optocoupled inputs. Nobody has this feature, don't waste money and time
Every relay can close electrical circuits at 125VAC@15A or 250VAC@10A as maximum
The output terminals are large for an easy connection to your power circuits
12VDC to 35VDC @ 100mA power supply required, 12VDC as minimum, 35VCD as maximum; you can use the same power supply of your stepper motor driver board
Compatible with all our stepper motor driver boards
| Slave and single mode configuration, selectable on board. |
 |
 |
Large output terminals for an easy connection. |
| Signal control terminals on board, easy to wire to your breakout. |  |
 |
Two high capacity relays on board. |
THE RELAY BOARD HAS A COMPLETE MANUAL WITH EASY INSTRUCTIONS, WIRING DIAGRAM, KCAM, MACH2 & MACH3 CONFIGURATION AND SOFTWARE EXAMPLES, DOWNLOAD HERE
YOU NEED ADOBE READER TO SEE IT
I TESTED THIS DRIVER BOARD USING KCAM SOFTWARE VER. 4.0 www.kellyware.com/kcam
YOU CAN DOWNLOAD FULL OPERATE DEMO VERSION AND RUN THE STEPPER SYSTEM
YES!, THE RELAY BOARD WORKS WITH MACH2, MACH3 AND ANY SOFTWARE THAT SENDS CONTROL SIGNALS THROUGH PARALLEL PORT!
YOU CAN DOWNLOAD OPERATE DEMO VERSION
|
Item |
Cost (USD) | |
| Twin Relay Board | $29.99 | |
|
Choose your shipping destination and add to your cart * |
||
| U.S. (via Mail) | $8.00 | |
| Alaska, Puerto Rico and Canada (via Mail) | $10.00 | |
| World (via Air Mail) | $12.00 | |
* If you purchase a driver board with their shipping cost, the shipping of the Twin Relay Board is FREE ! ! !
FedEx is also available, but the shipping cost could be more expensive than the relay board
