3-AXIS@10A CNC MICRO-STEPPER MOTOR DRIVER FOR LARGE MOTORS
 

TOP QUALITY NEW 3 AXIS STEPPER MOTOR DRIVER, THIS CAN MOVE UNTIL 10A STEPPER MOTOR, JUST WIRE TO YOUR PC PARALLEL PORT, PLUG IN A POWER SUPPLY AND CONFIGURE YOUR CAM SOFTWARE

FEATURES:

• Made with Top Surface Mount Technology

• Two phase bipolar (PWM Technology) this board doesn't need any external resistor for current motor adjustment.

• Resolution (Full step, 1/2 step, 1/4 step, 1/16 step) selectable via dip switch for each axis, also, you can get a resolution of 3200 steps per 360º revolution with a conventional 200 steps motor, ¡Imagine the fine movement that you will get!

• It can move 1.2A to 10A bipolar (4 to 8 leads), unipolar (6 leads) stepper motors

• 10Amps. as maximum capacity per axis

• Mounted in an aluminium clamping plate, you can screw it in a big heat sink if you are using large stepper motors

• For stepper motors large than 3.5A extra heat sink and fan is required

• IDLE indicator, when the driver doesn't receive any control signal, it decrease the current to 40% of the selected, it helps to avoid motor's overheating when it doesn't turn

• Individual axis enable/disable, via optocoupler input terminal (can be used as limit switch)

• 12 Adjustable levels stepper motor current via DIP switch on board

• DB25 MALE connector on board for PC parallel port

• All inputs signals are optocoupled for PC parallel port protection

• Full access to all unused DB25 pins connector via terminal block, easy connection for prototyping work

• 24VDC to 48VDC Power supply required, 24VDC as minimum, 48VCD as maximum

• 4 Wire, 6 Wire and 8 Wire (NEMA 17, NEMA 23, NEMA 34 and NEMA 42) Bipolar or Unipolar stepper motors can be used with 3 axis drive

• Fuse integrated for electrical protection

Optocouplers protect your PC parallel port isolating of the board.

This new model is mounted in an aluminium clamping plate, you can screw it in a big heat sink or in a case.

Big power supply terminal for easy connection.

All 24 power MOSFET use the clamping plate as heat sink, for motors large than 3.5A fan is needed.

The motor current is adjusted with the  DIP switch on board.

You can configure the stepper resolution with the DIP switch on board.

Fuse integrated per axis, as electrical protection. This fuse protect the printed circuit board tracks in case of short circuit.

Power LED on board per axis.

DB25 MALE connector, ideal for your PC parallel port.

Motor power disable per axis and breakout for unused DB25 pins, ideal for prototyping work.

THE 3 AXIS@10AMPS DRIVER BOARD HAS A COMPLETE MANUAL WITH EASY INSTRUCTIONS AND WIRING DIAGRAM, DOWNLOAD HERE

YOU NEED ADOBE READER TO SEE IT  

I TESTED THIS DRIVER BOARD USING KCAM SOFTWARE VER. 4.0 www.kellyware.com/kcam

KCam 4 Router/Mill software is designed to run low cost hobby CNC equipment. Program your paths using the built in G-code editor or import DXF, NC and PLT files. Create signs and plates using your CAD software and import your work into KCam

YOU CAN DOWNLOAD FULL OPERATE DEMO VERSION AND RUN THE STEPPER SYSTEM

YES!, THE RELAY BOARD WORKS WITH MACH2, MACH3 AND ANY SOFTWARE THAT SENDS CONTROL SIGNALS THROUGH PARALLEL PORT!

YOU CAN DOWNLOAD OPERATE DEMO VERSION

www.machsupport.com